Plant & Facilities
Bahadrabad, Haridwar.
One roof, end-to-end.
Melting, casting, machining, finishing, and inspection all on the same shop floor. Below: a walk through the bays.
13 machines · 250T-800T
High-Pressure Die Casting
YIZUMI 800T flagship plus 650T, 560T, 550T, 500T, 430T (×4), 420T, 320T, 250T. All fully automatic or auto-ladle/sprayer equipped.
1 ton/hour · plus Skelner 800 kg/hr
Tower Furnace & Melting
Aluminium melting capacity sized for parallel HPDC cell feeding. In-line degassing of molten aluminium before transfer.
16 machines · 5-axis capable
Machining Shop
Brother S700X2 ×4, HAAS VMC V3, CB Ferrari 5-axis A186, Cosmos CVM 1365, Kitamura ×3, Excel Taiwan, plus 6 Fanuc Robo Drills.
Automatic
Drill & Tap Line
Semi-automatic LED machining line for high-volume housing post-processing: drill, tap, deburr.
7-step · environment-friendly
Pre-Treatment Plant
Phosphating and conversion chemistry across seven stages. Water is reused after the ETP process; chemicals chosen for low environmental load.
Conveyor + manual booth
Powder Coating
Conveyor plant for production runs; manual booth for short runs and specialty colours. Curing oven in-line with the conveyor.
Spectrum Plus 10/12/6 RDS XXT
Standard Room: Zeiss CMM
1.2 × 1 × 0.7 m measuring envelope with VAST XXT probe. Climate-controlled standard room. Primary tool for first-article inspection and capability studies.
Zeiss roughness tester XXT
Surface Roughness Lab
Profilometry for sealing faces and machined surfaces. Used in tandem with the CMM for full geometric and texture validation.
100% visual + sampling
Final Inspection
Final-stage inspection desk with documented sampling plans before pack-out. Linked back to the non-conformity / root-cause analysis system.